|
Other Items from GPS III Pilot Accessories
Garmin Remote Antenna GA-26 - GA 26C Low Profile remote antenna (Includes: magnetic and suction mounts with 8 foot cable and BNC connector. This remote antenna is usable with any Garmin GPS that utilizes a BNC connector. Use with: GPS 55AVD, GPS 95AVD/XL, GPS 90, GPS 92, GPS III Pilot, GPSMAP 196, GPSMAP 295.
Garmin GA 26/27 series flange antenna mount - If you're mounting a GA 26/27 and GA 26C/27C antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.
Garmin Trunk Lip mount for Remote Antennas -
Garmin External Antenna GA-56 - GA 56 Low-Profile Antenna TSO'd to C129 Class A-1 w/ Hardware. This is the standard GPS Antenna that has been included with all Panel Mount Garmin GPS. It will work with any Garmin Panel Mount or Portable GPS. It includes the antenna, backing plate, and bolts. This is the stud type antenna. See related products for the flange mount type. Antenna Cable not included
Garmin External Antenna GA-56 - GA 56 Low-Profile Antenna TSO'd to C129 Class A-1 w/ Hardware. This is the standard GPS Antenna that has been included with all Panel Mount Garmin GPS. It will work with any Garmin Panel Mount or Portable GPS. It includes the antenna, backing plate, and bolts. This is the stud type antenna. See related products for the flange mount type. Antenna Cable not included
Garmin Carry Case for GPS III Series - This small carry case is designed for the GPS III Pilot Use with: GPS 89, GPS 90, GPS 92, GPS III Pilot
Garmin 4 pin Pwr/Data Cable for 92,3,196,295 - Garmin Power/Data Cable. This cable has raw wires without any connector attached to allow you to hard wire the unit into a raw power source such as the aircraft power system. It also includes additional wires for data transfer if you were to connect directly into another device for transfering data.
Garmin Dash Mount Bracket for GPS III Series - This Dash Mount Bracket was designed specifically for the GPS II, and GPS III Pilot. The unit snaps into the mount and a screw in the back secures the GPS. A pivitable joint allows the user to change the angle of the GPS for better viewing. Use with: GPS II, GPS III Plus, GPS III Pilot.
Garmin 4 pin PC Interface Cable for 92,3,196,295 - Garmin PC Interface cable. This cable attaches to the back of Garmin's units that have a round 4 pin plug. It allows you to perform database updates or operating software updates. The PC connector is a DB9 Serial connector that is on most computers. If you do not have a serial connector, you can purchase a USB to Serial adapter cable.
GA 26/27 series antenna suction cup mount (replace - So the suction cup mount that came with your GA 26/27 or GA 26C/27C antenna is gone and you're lost without it. No problem. Here's the replacement. This suction cup mount works with either the GA26 or GA27 remote antennas
Garmin Swivel mount bracket for GPS III Series -
|
